How Much Does A Bmw Brake Fluid Service Cost?

BMW brake fluid service cost is very dependent on where you take your car to have the fluid changed. It’s important that the person doing this has some knowledge about cars in general though! Be sure that whoever you choose knows how to do a brake fluid service properly, because it is different from changing any other kind of fluid change in a car service.

Average cost of BMW Brake fluid service

BMW Brake fluid service cost range anywhere from around $150-$360 or more depending on where you go and who does the work for you, with BMW charging between $129-149 for this job at dealerships. Lower costs are undoubtedly available for this service in the right places.

What you will get

Typically the average brake fluid change includes checking all of your tire air pressure, replacing cabin air filter if needed, and then checking and replacing the brake fluid and flushing out the transmission and engine cooler lines.

Many car owners will tell you that it is not hard at all to change your own brake fluid, but be careful! It’s also easy to have accidents when doing this kind of work too. The following information will help you do this job by yourself, with step-by-step instructions and detailed explanations of what you need to know.

How To Change Brake Fluid:

What you need to know before changing BMW brake fluid

  • Gather all needed tools before beginning work on any vehicle.
  • Work in a clean environment whenever possible, including wearing gloves while changing fluids since dirt can easily get into the lines and cause problems later.
  • It is critical that you remember to bleed all fluid lines after changing fluids!

Let’s Start

Step 1 – Begin by raising the car from the ground, then remove all wheel covers and jacking equipment. You will want to use a jack stand for added safety while working under the vehicle. Open the hood of your vehicle and locate the master cylinder which is bolted to one side of your engine compartment.

Step 2 – Using a wrench, remove the reservoir cap and do not lose this! Now, Remove the three bolts holding the master cylinder in place using a wrench and/or socket set, then pull the master cylinder from its mount position with one hand as you continue to hold onto it with your other hand.

Step 3 – Remove the brake fluid reservoir cap, then loosen at least one bleeder screw. As you do this, notice the presence of a “bleed screw” or “bleeding port”. Further, If the bleed screw/plug has been removed, then begin drawing out old brake fluid with an empty clear plastic jar for collecting used fluid, and insert it into the bleed port.

Step 4 – After bleeding all three ports on your BMW master cylinder, then tighten these screws down firmly using your fingers or you can use a wrench instead. Now that you have bled all three bleed screws/ports, then re-install the brake fluid reservoir cap along with the master cylinder into its original position.

Step 5 – Refill your brake fluid reservoir according to manufacturer’s specifications for capacity and type of fluid being used. Using the same plastic jar that you were using for draining fluid, now draw new brake fluid into it and pour this back into your master cylinder reservoir

Step 6 – Now go ahead and tighten the cap on your master cylinder reservoir securely, then check under your vehicle once more before lowering down from jack stands and/or jacking equipment so everything looks good.

Step 7 – Lower car gently onto the ground once more, then remove jack stands (if used during this project), then raise the car back into position using the engine’s hand crank or key in the ignition to activate the jacking system if you have one.

Lastly, enjoy driving safely knowing that you have just added years of life to your vehicle’s brake and clutch system with the proper maintenance of bleeding your BMW brakes and refilling your brake fluid!

Frequently Asked Questions

Steven Hatman
Steven Hatman

We break down every information into easy-to-understand articles that cover all the categories anyone who owns a car needs to know about, such as oil , brakes , tires and etc. Our car guide is free and updated regularly for you to use as a resource, not only when you have an issue with your car but even before buying a new or used car! We also give tips on what to look for in each category or part of your vehicle.